| 1. | Influence of dielectric film thickness and surface discharge on fingerprint discharge image
介质层厚度及其表面放电对指纹放电成像质量的影响 |
| 2. | Test methods for determining the relative resistance of insulating meterials to breardown by surface discharges
测定固体绝缘材料相对耐表面放电击穿能力的试验方法 |
| 3. | Recommended test methods for determining the relative resistance of insulating materials to breakdown by surface discharges
测定绝缘材料的表面放电击穿相应电阻的推荐试验法 |
| 4. | Recommanded test methods for determining the relative resistance of insulating materials to breakdown by surface discharges
用表面放电法测定绝缘材料相对的耐击穿性推荐试验方法 |
| 5. | Treatment for three stubborn problems in the safe and economical operation of cfbc boiler wear prevention of wall and heating surface discharge and cooling of bottom slag
炉壁和受热面防磨的治理及炉底渣排放与冷却 |
| 6. | Afcd would also investigate into the situation of water supply and surface discharge together with relevant departments and see how this could be improved
本署亦将与政务署调查水供应及地面排放情况，及寻找改善情况的方法。 |
| 7. | If the solid substance which accumulated in felt filtrate membrane is loss pressure increased through covered with filtration membrane surface discharged rapidly through clean water an outlet after automated cleaned by time figure or advanced established pressure figure
如果过滤膜内部粘合堆积固体残渣会加大损失压力，此压力达到设定压力或通过定时器自动清洗，清洗过的污物由下部排出口排出。 |
| 8. | The main works and conclusions in this paper are as follows : make three kinds of models and corresponding electrode system to simulate corona discharge , surface discharge and cavity discharge . in double shielding room , a large number of experiments were done on these models . lots of experimental data were obtained
本文的主要工作和结论如下：制作了电晕放电模型、气隙放电模型、沿面放电模型和相应电极，在实验室中模拟空气中电晕放电、油中电晕放电、固体绝缘内气隙放电、空气中沿面放电和油中沿面放电这五种绝缘缺陷。 |
